So I had some old LED strips that were hooked up around the window frame in my kid’s room which were not doing anything because the old WiFi controller I had on it was just so flaky and it connected via the cloud to, I’m assuming, China. I revisited getting it working, and it turned out that it was using an ESP12 chip. So I figured I should get that going with ESPHome (Check out my previous article about ESPHome) to give me total local control with Home Assistant.

NOTE: This worked out for me because I already had a light strip and controller. If you were purchasing this stuff from scratch, I would recommend just using a Wemos D1 Mini with a WS2812B strip and a power supply. I did this behind my TV and it gives you so many more options with the addressable lights and it doesn’t cost a lot more. And on top of that, it is a lot easier to do than this one. I plan on doing a write-up on how to do that some time this week. Stay tuned.

Here’s what you will need:

• LED Controller
• RGB Strip
• 12v Power Supply
• USB to serial with pinouts – You only need one of these if you are going to flash more than one controller
• Soldering iron
• Jumper wires

Soldering the wires

1.  First, crack open the case. I found it easiest to wedge a flat head screwdriver where the connector is.
2. Next, you need to solder a wire going from the pin IO0 (it looks like it says 100) to one of the GND pins. And solder one male to female jumper onto the Rx pin and one onto the Tx pin.
   

3. Now connect the LED Controller’s RX to the USB-Serial adapter’s TX. And the LED Controller’s TX to the USB-Serial’s RX.
4. Plug the USB to Serial into your Home Assistant computer that has ESPHome on it.
5. In ESPHome, click the + symbol and fill in the information. Then edit that device you created, and add the following to the end and save it:

   output:
     - platform: esp8266_pwm
       pin: GPIO14
       id: 'color_red'
     - platform: esp8266_pwm
       pin: GPIO05
       id: 'color_green'
     - platform: esp8266_pwm
       pin: GPIO12
       id: 'color_blue'
   
   light:
     - platform: rgb
       name: "Kids LED"
       red: color_red
       green: color_green
       blue: color_blue
       
       effects:
         - random:
             name: Rainbow
             transition_length: 5s
             update_interval: 7s
         - flicker:

    

6. Go to the ESPHome main page, click the drop down at the top, select your USB-Serial adapter. You may need to restart ESPHome for it to show up. Then click ‘Upload’ on the device you created. This should upload the code to the LED Controller, and the controller should connect to WiFi. From here, you can update the device over the air, and you don’t need the USB to serial device.
7. All that is left is to add it into home assistant. Go to “Configuration -> Integrations”. You should see the device at the top. Just follow the steps there to get it added. The password you need to put in is the API password you setup in step 5.

That’s it. You should now be able to control that strip from Home Assistant. I have it set to slowly turn on when their Amazon Echo’s alarm goes off.