Home Automation with Home Assistant and ESP8266, 3D Printing, and other Technology
Setting up your Klipper config often takes a lot of time. Doing it all over again the second time isn't a whole lot easier. Backing it up allows you be back up and running in no time.
It’s been a while since I have posted, but someone on Reddit asked me about my Android widget that shows information from my 3D printers. This will be a quick write up to point you in the right direction, so I won’t have step by step instructions. Keep in mind that this only works when your phone can actually connect to Moonraker. So if you are away from home, it won’t work unless you have a VPN.
I recently saw this on Amazon and figured I could print that. I’ve also been wondering about embedding an object into the middle of a 3D print, so I figured this would be a good project. So I bought these blades, and measured them, and started working in Fusion 360. In hindsight, I think that some jigsaw blades would have been easier when modeling since there aren’t any weird angles to deal with. Either way, it wasn’t too difficult.