Home Automation with Home Assistant and ESP8266, 3D Printing, and other Technology
About 8 months ago I purchased a Creality Ender 5. I wrote a mini getting started guide about it. In that guide, I mentioned OctoPrint, and how I would do a separate write-up on that. I installed OctoPrint after a few prints. I wanted to be able to monitor the prints remotely since the printer is down in the basement. This write-up goes through my setup and settings along with the plugins I used.
As I talked about in my last post about the FilaWeigher, I wanted to add MQTT and temperature/humidity(Using the BME280) to that project. Well, I've done that. Refer to the previous post for more details. But now for this one, I'm just going to focus on the updated code and schematics, and the Home Assistant integration via MQTT. I'm going to leave the old post up for the people that don't want MQTT or the BME280 sensor. This version also has JSON output of all the sensors which allows for OctoPrint integration(I actually just finished up that plugin and I'm going to be posting that up soon).
UPDATE: I have written an updated post(1 year later) about this printer. Be sure to read that one after this one as there is some update info in there. Here is the link to it.
About 2 months ago, I decided to finally pull the trigger on purchasing a 3D printer. I settled on the Creality Ender 5. I felt that it struck the right balance between bed size, price, and the community behind it. Although the community isn’t extremely large on its own, I felt that it’s similar enough to the Ender 3 that I should be able to able to figure out any issues by using the same types of advice. I have found that to be accurate for the most part. In addition, it looks like the number of Ender 5 users have increased sharply around the time I bought it. I also liked how it had the 4 vertical rails, which I’m sure gives it a lot more stability.